Eaton 9130 2000 103006436-6591 UPS battery replacement pack
Replacement Eaton 9130 2000 103006436-6591 non-spillable sealed lead acid valve regulated UPS system batteries, AGM and VRLA that can be mounted on its side offered direct from warehouse at low cost
Below is the details of the batteries your will require to replace in your UPS system for the Eaton 9130 2000 103006436-6591, it stores its required energy onboard using batteries, these are used to filter the mains electrical input before outputting a clean supply and is powered by 12v cells, and comes with 8 x 12-volt batteries and that is what this offer is for, they are of course recyclable as they are made from lead meaning that they are a environmentally friendly form of protection, and by fitting them in your machine you are prolonging the life of this equipment which is also a bonus rather than it ending on land fill, and why not there are years of life left in it yet.
- Eaton 9130 2000 103006436-6591 battery replacement
The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise
You would expect these kind of batteries to last between two to five years in this kind of device, this can vary greatly on conditions, using the system as part of the office furniture is not the best idea, it needs ventilation, the batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span
The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office
Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.
Voltage = 12-volts
Capacity = 9Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
This offer is for a set of 8 batteries for use in the Eaton 9130 2000 103006436-6591 the overall size of the batteries are
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
Hot swap capable, no maintenance required
