¢ saver slide show ( page 29) or change the colour scheme of the display ( page 29). Choose from a selection of ringtones specially composed for your SL610H PRO or load your ¢ own ( page 30). If you don't (always) want it to ring ¢...
Brief overview Brief overview ¢ 1 Display in idle status 2 Battery charge status ( ¢ page 11) ¢ 3 Display keys ( page 4) 4 Message key ( page 21) Access to call and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press...
Brief overview Display symbols The following symbols are displayed dependent on the settings and the operating status of your telephone: ¢ Signal strength page 11) ¢ ¼ or ECO Mode+ icon page 23) ¢ Bluetooth activated ( page 26) ô õ...
ƒ If you give your Gigaset to a third party, make sure you also give them the user guide. Remove faulty bases from use or have them repaired by our Service, as they could interfere with other wireless services.
First steps First steps Checking the package contents: One Gigaset handset, one battery, one battery cover, one charger, one power adapter for the charger, one belt clip, one user guide. Installing the charger The charger is designed for use in dry rooms in a temperature range of +5°C to +45°C.
Inserting the battery and closing the battery cover Please note Use only rechargeable batteries recommended by Gigaset Communications GmbH, as this could result in significant health risks and personal injury. For example, the outer casing of the battery could be destroyed or the battery could explode.
Registering the handset Your Gigaset handset can be registered on up to four bases. You must register the handset on both the handset (1) and the base (2). Once the registration process has been completed successfully, the handset returns to idle status.
Page 13
First steps 1) On the handset ¤ §Register§ Register Press the key below on the display screen. A message appears stating that the handset is searching for a base that is ready for registration. Please note If the handset is already registered to at least one base, start the registration process as follows: ¢...
You can connect a headset to the left-hand side of your telephone with the 2.5 mm jack connector (available from Service). See the relevant product page at www.gigaset.com for information on recommended headsets. The headset volume corresponds to the settings for the earpiece volume.
Using the phone Using the menus • The menu view can be expanded (expert mode ) or simplified. Expert mode is the active default setting. Main menu (first menu level) ¤ When the handset is in idle status, press the right control key v to open the main menu.
Menu overview Menu overview Setting simplified or expert mode • The menu view can be expanded (expert mode ) or simplified. Expert mode is the active • default setting. Menu options that are only available in expert mode are marked with the icon.
Page 17
Menu overview Ï Settings Date/Time ¢ Audio Settings Handset Volume page 30 ¢ Handsfree Profiles • page 30 ¢ Advisory Tones page 32 ¢ Silent Alert page 31 ¢ Ringtones(Handset) • page 30 Music on hold (dependent on base) ¢ Display + Keypad Screensaver page 29...
Making calls Making calls Deactivating the One Touch Call ¤ §OFF§ In idle status, press the display key ¤ Press and hold the hash key #, to deactivate the One Touch Call. Making an external call Ending a call External calls are calls using the public tele- phone network.
Using the directory and lists ¤ Press and hold handsfree key d while Using the directory and placing the handset in the base/charger lists and for a further 2 seconds. For instructions on adjusting the handsfree ¢ volume ( page 30). Directory Switching to mute You can save up to 500 entries in the direc-...
Using the directory and lists Caller Picture: Copy Entry If required, select a picture to be dis- to Internal: Send a single entry to a hand- ¢ played when this person calls (see "Using set ( page 19). the Resource Directory", page 31). vCard via SMS: Send a single entry in Prerequisite: Calling Line Identification vCard format via SMS.
Using the directory and lists Using quick dial keys A number is displayed: ¢ ¤ §Options§ Copy to Directory ¤ ¢ Press and hold the required quick dial key ¢ Complete the entry ( page 17). page 28). Copying a number or e-mail Transferring the directory to address from the directory another handset...
Using the directory and lists Reminder call on an anniversary Managing entries in the redial list In idle status, a reminder call is indicated on Press the key briefly. the handset display and by the selected Select entry. ringtone and volume that has been set for ¢...
Using the directory and lists List entry Message key function (dependent on base) New messages are displayed at the top. Example of list entries: Opening lists All Calls Use the message key f to open the fol- ™ Frank lowing list selection: 14.05.11, 15:40 š...
Using the network mailbox Lists containing new messages are at the top of the list and are marked in a bold font. Messages & Calls Calls: Missed Alarms: SMS: Back Select a list with q. To open, press §OK§ Missed alarms list Missed (unacknowledged) appointments ¢...
Days on which appointments have already been saved are highlighted. You are helping to protect the environment Select the required day in the with your Gigaset handset. graphical calendar. Reducing energy consumption The selected day is highlighted. The current day is highlighted in the same colour as the Your telephone has a power-saving adapter digits.
Setting the alarm clock Signalling appointments and Displaying missed anniversaries appointments, anniversaries An appointment reminder is signalled in idle The icon
and the number of new entries status for 60 seconds with the selected ring- are shown in the display. The most recent tone at the volume that has been set for ¢...
Using a handset as a room monitor (Babyphone) The wake-up call sounds for 60 seconds. If Warning! no key is pressed, the wake-up call is repeated twice at five minute intervals and Always check the operation of the then switched off. room monitor before use.
Using Bluetooth devices Changing the set destination Using Bluetooth devices number É ¢ ¢ Before you can use your Bluetooth device, Room Monitor ¤ activate Bluetooth, ensure the devices are Enter and save number as described in visible and then register the handset. "Activating the room monitor and enter- ing the destination number"...
Page 29
Using Bluetooth devices §Options§ Press the display key. Changing the name of a Bluetooth device Trust Device ¢ s (select entry) §OK§ Select and press Open list Enter the PIN for the Bluetooth §Options§ Press the display key. device you want to register and §OK§...
Defining handset settings Defining handset Changing display key assignments ¤ Press and hold the left or right side of the settings display key. The list of possible key assignments is opened. The following can be selected: ¢ Quick dialling numbers and Room Monitor ( page 25) ¢...
Defining handset settings • Setting the display Setting the display backlight Ï ¢ ¢ Display + Keypad ¢ Setting the screensaver/slide show Display Backlight The current setting is displayed. When in idle status, a picture or a slide show ¤ (all the pictures are displayed one after the You can enter data in the following fields: other) from the Screensaver folder of the...
Defining handset settings Changing the handsfree/ Profile 4 Optimised for special connections. If the earpiece volume default setting (profile 1) does not provide optimum sound, please give this a try. In idle status: In idle status: ¢ Ï ¢ Open the menu for setting the Audio Settings ¢...
Defining handset settings If time control is activated: Deactivating the ringtone permanently Suspend ring. from: Enter the start of the period in 4-digit for- Press and hold the star key. The ó icon appears in the display. mat. Suspend ring. until: Reactivating the ringtone Enter the end of the period in 4-digit for- mat.
Defining handset settings If you have saved a picture in an invalid file In idle status: Ï ¢ ¢ format, you will see an error message after Audio Settings ¢ selecting the entry. Advisory Tones ¤ Sounds: You can enter data in the following fields: Switch between the sounds using the q key.
Questions? For rapid assistance, refer to this ¥ 2. Call divert set for "All Calls". user guide or visit www.gigaset.com/pro. Deactivate call divert. The trade outlet will be happy to help with 3. The phone only rings if the phone number has further questions relating to your ¥...
Our environmental mission statement This crossed-out wheeled bin symbol on the product We, Gigaset Communications GmbH, bear means the product is social responsibility and are actively com- covered by the European mitted to a better world. Our ideas, technol- Directive 2002/96/EC.
75% relative humidity Due to the constant progression in battery development, the list of recommended bat- Bluetooth teries in the FAQ section of the Gigaset Radio frequency range 2402–2480 MHz Customer Care pages is regularly updated: Transmission power 4 mW pulse power...
Appendix Writing and editing text Writing names/an SMS (depending on the base) ¤ The following rules apply when writing text: Each key between Q and O is Enter the individual letters/characters by pressing the corresponding key. assigned several letters and characters. Control the cursor with u v t s.
Establish a connection to your handset. ¤ ¢ To enable your handset to communicate Select [Settings] [Device properties] with the PC, the "Gigaset QuickSync" to open the [Device] tab. program must be installed on your PC ¤ Click on [Firmware update]. (free to download at www.gigaset.com/pro/gigasetSL610HPRO).
Accessories Ordering Gigaset products You can order Gigaset products from your specialist retailer. Use only original accessories. This will avoid possible health risks and personal injury, and also ensure that all the relevant regulations are complied with.