Table of Contents
Advertisement
Problem
hours the drying cycle ends auto-
matically.
1) Only dryers with conductance programming
2) Only dryers with removable filter
Machine settings
Setting
BUZZER permanent off
Water hardness
Water contains, a variable quan-
tity of limestone and mineral
salts of which quantities vary ac-
cording to geographical loca-
tions thus varying its conductivi-
ty values.
Relevant variations of the con-
ductivity of the water compared
to those prefixed by the factory
could slightly influence the re-
sidual humidity of the laundry at
the end of the cycle. Your dryer
allows you to regulate the sensi-
tivity of the drying sensor based
on conductivity values of the
water.
Technical data
Dimensions (mm)
Max. depth
(with the appliance door open)
Max. width
(with the appliance door open)
Electrical connection
Drum volume
Weight of the appliance
Laundry: max. weight
www.zanussi.com
Possible cause
Load volume too big.
Laundry insufficiently spun.
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and ANTI-CREASE buttons
and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
1. Turn the programme selector to any programme.
2. Press simultaneously the ANTI-CREASE and START/PAUSE but-
tons and hold down for approx. 5 seconds. Lights show the current
setting:
– END - low conductivity <300 micro S/cm
– DRYING - medium conductivity 300-600 micro S/cm
– DRYING and END - high conductivity >600 micro S/cm
3. Press the START/PAUSE button sequentially until you set desired
level.
4. To memorize setting press simultaneously the the ANTI-CREASE and
START/PAUSE buttons or turn knob to OFF position
Width / Height / Depth
Voltage
Frequency
Fuse
Total power
Reduce load volume.
Laundry must be adequately spun.
Implementation
85 x 60 x 58 cm
1090 mm
950 mm
230-240 V
50 Hz
13 A
2600 W
108 l
32,5 kg
7 kg
Remedy
11
Hide quick links:
Advertisement
Table of Contents
